320 Mag Lock

The 320+ is smaller is size and holding force which makes it ideal for interior door traffic control.

DSM + MBS

Door Status Monitor + Magnetic Bond Sensor:  These are two internal switches used to send signals through two additional sets of wires.  These wires can hook directly back to the power supply for mulit-door operation (vestibule, air lock, man trap, etc).  Most often, these wires run to a remote monitoring station that constantly checks the status of all security doors in a building.  The monitor wants to know if a door is open, or if it is closed and securely locked.  DSM tells the monitor the door is closed.  MBS tells the monitor it is securely locked.

RTD

Relocking Time Delay: This is an inline timer that splices into the wires near the mag lock.  It sets the unlock time of the door from 1 - 60 seconds.  If your power supply already has a timer you do not need this option.

ATS

Anti-Tamper Switch: An add-on switch similar to the DSM and MBS, but this switch monitors the lock integrity.  Should someone tamper with the lock, the ATS will send a signal to the alarm system.

L1

LED Indicator: Adds an LED light to the mag lock that glows when power is running to the lock.  Only available when used with the DSM + MBS option.

HDB

Herculite Door Bracket: Attaches to the top of either a 1/2'' or 3/4'' Herculite (glass) door to allow mounting of the armature without having to drill through the door, easing installation time, frustration, and cost.

TJ

Top Jamb Mounting Bracket: Mag locks typically install on outswing doors.  But if you have an inswing door, the installation will require a ''Z'' shaped bracket.  Here, the mag lock mounts to the face of the door frame instead of under the header.  The ''Z'' bracket mounts one end to the door and the other end accepts the armature plate.  This bracket basically moves the plate from the door up to the mag lock location.  The L1 option is not available if you use the TJ bracket.